Daihatsu F300 Service Manual page 1222

•
•
•
•
(2) Liberally apply engine oil to the journal sections and
thrust bearing sections.
(3) Assemble the camshaft on the cylinder head in such a
way that the locating pin for the camshaft timing belt
pulley comes exactly at the top position.
Apply
engine
Oil
to the camshaft journal section .
(4) Apply the Three Bond 1104 to the camshaft cap No. 1
attaching section of the cylinder head at those points
shown in the right figure.
NOTE:
• Be careful not to allow any oil to flow into the bearing
cap attaching holes.
(5) Install the camshaft bearing caps in the sequence of
embossed figures on the caps .
NOTE:
Before the camshaft bearing caps are installed, wipe off
any bond oozed from the camshaft cap No. 1.
(6) Assemble the valve rocker arms and wave washers onto
the valve rocker shaft, while applying engine oil liberally
as
shown in the right figure.
NOTE:
• The intake valve rocker shaft can be identified by the
recessed sections .
EM-81
ENGINE MECHANICALS
No.1