Daihatsu F300 Service Manual page 1307

• ENGINE INSTALLATION
•
•
•
1. Installation of engine harness onto engine
{1) Install the engine wire to the engine.
(2) Connect the engine wire clamp.
(3) Connect the alternator connector and terminal.
2. Sling the engine, using a chain block. Place the engine in
the engine compartment.
CAUTION:
Be very careful not to allow the engine to hit to the
vehicle body or other parts .
3. Connection of engine and transmission
(1) Lower the engine down to a height where the engine
can be connected to the transmission with ease, using
a chain block.
(2) Carefully bring the engine toward the transmission side.
Insert the transmission input shaft into the clutch disc.
(3) While correcting the angle of the engine, align the at-
taching bolt holes of the transmission with those of the
engine.
(4) Temporarily connect the engine with the transmission
by inserting the attaching bolts so that the transmission
may not be detached from the engine.
4. Installation of engine mounting
(1) Install the engine mounting provided at the left side of
the engine to the engine bracket.
(2} Adjust the engine position. Secure the engine mounting
to the engine mounting attaching section at the vehicle
body with the four bolts.
Tightening Torque: 29.4 - 44.1 N-m (3.0 - 4.5 kgf-m)
EM-165
ENGINE MECHANICALS