Daihatsu F300 Service Manual page 1231

ENGINE MECHANICALS
INSTALLATION OF CYLINDER HEAD WITH
MANIFOLDS
1. Clean the cylinder block head bolt holes.
2. Clean the cylinder block upper gasket surface. Install the
cylinder head gasket, while aligning it
with
the pin ring for
locating use.
3. Turn the crankshaft so that the crankshaft key groove may
come at the
top
position.
4. Install the cylinder head onto the cylinder block, using chain
block.
5.
CAUTION:
• Be careful not to allow the cylinder head to hit to the
vehide body and/or other parts.
Coat each cylinder head bolt with a thin film of engine oiL
Using these bolts, install the cylinder head to the cylinder
block. Tighten the bolts evenly over two or three stages,
following the sequence shown in the right figure.
Tightening Torque:
58.8- 66.7 N·m (6.0- 6.8 kgf-m)
NOTE:
•
Make sure that all the bolts are torqued uniformly to a
constant level, not only they are torqued within the
specified range.
EM-90
•
""""""'"'
i~
0 0
0 0
®
® ®
@)
®
@
Q)
®
0
0 0 0
~
•
~,_,,