Daihatsu F300 Service Manual page 1158

•
•
•
•
(4) Detach the spark plug wires at the cylinder head side.
NOTE:
• Be sure to hold the rubber boot during the spark plug
wire disconnection. Never remove the spark plug wire,
holding the cord portion.
(5)
Disconnect the
PCV
hoses from the cylinder head
cover .
(6) Remove the accelerator cable bracket from the cylinder
head cover.
(7) Loosen the nine bolts (10 mm) over two or three stages
in the sequence shown in the right figure.
After removing the bolts, proced to remove the cylinder
head cover.
NOTE:
1. Be sure to loosen the bolts progressively and unformly
over two or three stage.
2. Be very careful not to damage the grommets of the spark
plug tubes.
3. The timing belt cover attaching bolt
<D
should pulled out
fully.
[HD-E Engine]
(1) Removal of the air intake chamber
<D
Disconnect the vacuum hoses from the air intake
chamber.
®
Remove the air intake chamber by removing the
three attaching screws and two clamps .
EM-17
ENGINE
MECHANICAL~
0 0 0