Daihatsu F300 Service Manual page 1014

•
•
•
•
FUSIBLE LINK BLOCK
If the fusible link is blown out repeatedly, the likelihood is that
there exists a short in the relevant system. Hence, perform
checks for possible systems, referring to the wiring diagram.
Replacement
1. If visual inspection reveals that the fusible link is blown out,
replace it with a new fusible link with the designated rating.
NOTE:
1. Before the fusible link is replaced,
be
sure to turn OFF
the ignition key .
2. Care must
be
exercised to ensure that the fusible link is
not twisted during the removal/installation. If the fusible
link is replaced forcibly,
it
will cause breakage or poor
contact .
HW-7
~
HARNESS & WIRING DIAGRAM