Daihatsu F300 Service Manual page 1243

ENGINE MECHANICAL$
FILLING OF ENGINE OIL AND
COOLING WATER
1. Filling engine oil
(1) Clean the oil drain plug. Install it with a new gasket
lnterposed.
NOTE:
Remove any remaining gasket material from the oil pan,
using a gasket scraper.
Tightening Torque:
19.6- 29.4
N-m
(2.0- 3.0
kgf-m)
(2) Fill the engine with engine oil.
The oH should' be API grade SG or SF multigrade vis-
cosity, fuel-efficient oil.
Oil Capacity
When only engine oil is changed: 3.3 dm
3
When engine oil is changed and oil filter is
replaced: 3.5 dm'
After engine has been overhauled or when engine
oil has been drained completely from engine:
3.8 dm
3
(3) Check the engine oil level.
(See page LU-9.)
2. Filling cooling water
(1) Install the cooling water drain plug with new gasket.
(2) Fill the radiator and reserve tank with antifreeze solution
in accordance with the instructions of the manufacturer
of the anf1freeze solution.
CAUTION:
• Use a Good brand of ethylene-glycol base antifreeze
solution.
Coolant Capacity {Vehicle with Front Heater):
5.5
dm
3
[excluding 1.0 dm
3
for reserve tank]
EM-102
Classification
API SG
or
SF
' " ' " I I I I I
!"FI II 101
~II
J<l \CI ',Cl
m
)II "" '"' I"
o•no-IK,.-1111-il 1-ll Ill olll• ru,, •tl> 12it r:m l"ll!r
At...,.pl><tt l'tmp«>tUr< "'"!« ~n,;t>pat<d b<fo<r "'" ool t!..>"(""
•
•
•