Daihatsu F300 Service Manual page 1183

ENGINE MECHANICALS
(3) Tighten the crankshaft timing belt pulley bolt.
Tightening Torque: 88.3- 98.0 N-m (9.0- 10.0 kgf-m)
NOTE:
• Prevent the crankshaft from being rotated by placing the
gear shift lever in the 5-th gear.
4. Installation of camshaft timing belt pulley
(1) Install the camshaft timing belt pulley on the camshaft
in such a way that the "F" mark can be seen and the
locating pin hole is aligned.
NOTE:
• Remove any oil or water from the camshaft timing belt
pulley. Keep the pulley clean.
(2) Install the three attaching bolts of the camshaft timing
belt pulley, while preventing the pulley from turning by
using SST.
Tightening Torque: 14.8 - 21.5 N-m (1.5 - 2.2 kgf-m}
SST: 09278-87201-000
CAUTION:
• Never allow the camshaft to tum.
5. Installation of timing belt
CAUTION:
• Do not try to pry the timing belt with a screwdriver or the
like.
• Do not allow the belt to come into contact with oil, water
or dust.
• Do not bend the belt at a sharp angle or tum the belt
inside out.
• Perform the engine turning operation at the crankshaft
side.
• Do not utilize the tension of the timing belt when tighten-
ing the set bolt of the timing belt pulley.
• When the timing belt is reused, install the timing belt in
such a way that the direction of the arrow put during the
removal may match with the engine rotation direction.
• The adjustment of belt tension should be made when the
cylinder block and its ambient temperatures are in be-
tween 5 -
so·c .
EM-42
•
WFE9Q.EM11 1
•