Daihatsu F300 Service Manual page 1198

•
•
•
•
9. Removal of distributor
(1) Disconnect the distributor wire connector.
(2) Remove the distributor from the cylinder head by
removing the
two
attaching bolts.
NOTE:
• Since the remaining engine ·oil will flow out, be certain
to place a cloth or the like.
10. Removal of engine wire hamess.
( 1) o·1sconnect the flowing connectors.
(j) Throttle possition sensor (j)
®
Intake air temperature sensor®
®
Idle speed control VSV
®
@ EGR VSV and harness clamp @
@ Air conditioner idle up VSV
®
®
Idle up VSV connector
(Pressure sensor, Pressure VSV and clamp. @)
®
Air conditioner water temperature switch.
<V
@ Water temperature sender gauge@
®
Water temperature sensor®
(2} Disconnect the four injector connectors.
(3) Remove the engine wire clamps and engine ground
cables.
11. Remove the radiator hose No. 1 from the radiator upper tank
by loosening the
two
clamps and attaching bolts .
EM-57
ENGINE MECHANICALS