Daihatsu F300 Service Manual page 1299

ENGINE MECHANICALS
(5) Measure the flywheel runout, using a dial gauge.
Allowable Runout Limit: 0.1 mm
NOTE:
Replace the flywheel if
its
runout exceeds the allow-
able limit.
9. Assembly of clutch disc and pressure plate
(1) Insert the following SST into the crankshaft rear end.
SST: 09301-87601-000
(2) Install the clutch disc.
(3) Install the pressure plate, lining up the locating pin of
the pressure plate. Tighten the attaching bolts to the
specified torque.
Tightening Torque:
14.7-21.6
N·m
(1.5- 2.2
kg1-m)
10. Install the thermostat in the cylinder block in such a way
that the jiggle pin section may come at the upper side.
CAUTION:
Make sure to install the jiggle pin of the thermostat in the
correct direction. Failure to observe this precaution will
be cause of overheating.
11.1nstall the water inlet.
Tighten the three water inlet attaching bolts to the specified
torque.
Tightening Torque:
5.9 - 8.8
N·m
(0.6 - 0.9
kgf-m)
12.
Installation of water pump
(1) Install a new water pump gasket on the cylinder block.
(2) Install and tighten the three water pump attaching bolts
and two nuts to the specified torque.
Tightening Torque:
14.7 - 21.6
N·m
(1.5 - 2.2
kg1-m)
NOTE:
• When the stud bolts have been replaced, apply the
Three Bond 13778 to the threaded portion at the cylinder
block side.
EM-158
•
""""'""'
•
•