Daihatsu F300 Service Manual page 1186

•
•
•
(9) Ensure that the stamped marks of the crankshaft timing
belt pulley and camshaft timing belt pulley are aligned
with the corresponding indicators.
If the stamped mark is not aligned with the indicator,
repeat the operations from the step (1) onward.
6.
Check of timing belt tension
When the midpoint of the belt at the tension side is pushed
5.0 mm, ensure that the pushing. force is
Specified Pushing Force: 7.8-15.7 N (0.8 -1.6 kgf)
(When belt is deflected
5.0
mm)
If the belt does not conform to the specification, repeat the
operations from the step
15 (4)
onward.
7. Installation of timing belt cover
(1) Install the timing belt cover No. 1 (lower side) with three
bolts.
NOTE:
• Attaching bolts@ and@ in the figure are tightened both
upper and lower side cover.
(2) Install the timing belt cover No.2 (upper side) with five
bolts.
Tightening Torque: 2.0 - 3.9 N·m (0.2 - 0.4 kgf-m)
(For both upper and lower cover)
NOTE:
• First, attaching bolts
<D
and @) should be installed .
8.
Installation of crankshaft pulley
( 1) Prevent the crankshaft from turning by placing the gear
shift lever in the 5th gear position, and pull the parking
break lever.
(2) Install the crankshaft pulley on the crankshaft timing belt
pulley with four bolts.
Tightening Torque:
19.6 - 29.4
N·m
(2.0 - 3.0
kgf-m}
EM-45
ENGINE MECHANICALS
WNU89.£M107
Pushing force
7.8- 15.7 N
(0.8 - 1.6 kgf)
~114