Daihatsu F300 Service Manual page 1301

ENGINE MECHANICAL$
19. Installation of the oil cooler.
(1) Install a new "0" ring.
(2) Connect the oil cooler hose to the oil cooler.
(3) Place the rib for locating the oil cooler to the cylinder
block. Then install the oil cooler with the set bolts.
(4) Tighten the set bolts to the specified torque using the
following SST.
SST: 09268-87704-000
Tightening Torque: 24.5 - 34.3 N-m (2.5 • 3.5 kgf-m)
(5) Connect the oil cooler inlet pipe into the oil cooler hose
and install the hose band.
(6) Install the oii cooler
pipe
to the cylinder block with a new
gasket interposed.
20. Installation of oil filter
(1) Thinly apply engine oil to the oil seal of the oil filter.
(2) Screw in the oil filter until the oil seal of the oil filter
comes in contact with the oil pump or the contact sur-
face of the oil cooler.
(3) Then, rotate the oil filter further one complete turn 360-
degrees, using the following SST.
SST:
09228-87201-DOO
EM-160
,.---------1·
09268-87704-000
09228-
87201-
000
•
•