Daihatsu F300 Service Manual page 1227

ENGINE MECHANICALS
7. Install the carburetor heat insulator to the intake man Hold.
NOTE:
Be careful not to damage the gasket. Replace the heat
insulator
with
a new part if the gasket exhibits damage.
8. Install the carburetor to the intake manifold.
Tightening Torque: 14.7- 21.6 N-m (1.5- 2.2 kgf-m)
9. Connect the connectors of the solenoid valve and outer vent
valve.
10. Connection of vacuum hoses
Connect the vacuum hose, as shown in the figure.
Outer vent hose to outer vent
Choke breaker to TVSV
Carburetor to BVSV
Throttle positioner to carburetor
Vacuum hose to gas filter
Vacuum hose to distributor
11. Connector the hot water circulating hose to the carburetor.
Attach the hose bands.
12. Connect the fuel hose to the carburetor.
Attach the hose bands.
13. Temporarily install the cylinder head cover to the cylinder
head.
EM-86
•
•
•
•