Table of Contents
Advertisement
No: The phone number is suppressed.
Standard: Both the DDI parallel to the internal number and the MSN on the
PTMP connection are displayed on the PTP connection over which the
subscriber is called (if the subscriber is not a member of the call distribution for
this connection, the first MSN is presented).
Exchange line dependent: The phone number to be presented is configured
separately for each external connection under Expert.
Note:
For the option No, the telephone service Calling Line Identification
Restriction (CLIR2) must be released by the network provider.
On a connection with a GSM gateway, the phone number presentation
configured in the PBX is not used because the actual phone number
presentation is directly configured in the individual GSM gateway.
On a connection with CLIP no screening enabled, the number presentation
defined here is not considered.
Configuring Number Presentation (Outgoing) for Group
Proceed as follows:
• Separately for groups
• Separately for configurations
• Using the configuration manager
Note: As described in the following, the setting is also possible via profiles (...
> Profiles > Configuration > Configure > ...). If the check box Profile-
controlled settings has been selected, the property set in the right-hand
column will apply. For assignment of the profile, see chapter Settings >
Profiles.
Requirements:
• Configured external numbers
1. Open the page Groups > Properties > Exchange line settings.
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016
Number Presentation (Outgoing)
Configuring Number Presentation (Outgoing) for Group
Functions
473
Advertisement
Table of Contents
