Multi-Path Call Forwarding; Switching Multi-Path Call Forwarding For Subscriber On/Off - Auerswald COMpact 5000 Operation Manual

Multi-path Call Forwarding

Multi-path call forwarding is used to signal external calls, in addition to call distribution for an
internal or an external number, e.g., on a mobile phone. Multi-path call forwarding is also
executed if the "main phone number" is, for example, busy. It is not executed when call
forwarding for external numbers is enabled.

Switching Multi-path Call Forwarding for Subscriber On/Off

If multi-path call forwarding is enabled for a subscriber, external calls to the subscriber are
signaled additionally to other internal telephones or external connections.
Proceed as follows:
• Separately for subscribers
• Separately for configurations
• Using the configuration manager
• Using a character string on the internal telephone (see section Short Reference)
Note: As described in the following, the setting is also possible via profiles (...
> Profiles > Configuration > Configure > ...). If the check box Profile-
controlled settings has been selected, the property set in the right-hand
column will apply. For assignment of the profile, see chapter Settings >
Profiles.
1. Open the following page:
• For admin: Subscriber (scr.) > Properties > Reachability
• For user: Subscriber Properties > Reachability.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Select or clear each the Multi-path Call Forwarding check box.
Enables multi-path call forwarding.
Disables multi-path call forwarding. (No other action is required.)
4. If you have enabled multi-path call forwarding, enter the destination number in the
Destination number entry field under Multi-path Call Forwarding. Possible entries:
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016
Switching Multi-path Call Forwarding for Subscriber On/Off
Functions
Multi-path Call Forwarding
437