Switching Pbx Call Assist On/Off; Configuring Subscribers For Lan-Tapi - Auerswald COMpact 5000 Operation Manual

Pbx for analogue/isdn/internet telephony

Hide thumbs Also See for COMpact 5000:

Table of Contents

Switching PBX Call Assist On/Off

PBX Call Assist is a CTI software available from Auerswald. Its use must be switched on in the

PBX. If PBX Call Assist is switched on, all available TAPI lines are administrated by the corre-

sponding server software UCServer. Other TAPI applications cannot be used in parallel.

Proceed as follows:

• Using the configuration manager

Requirements:

• PBX Call Assist function enabled (optional, see chapter Important Information > Product

Details > Basic Assembly and Extensions)

1. Open the page Functions > LAN TAPI.

2. Select or clear the Use PBX Call Assist check box under SETTINGS.

Further steps:

• Install the server and client software. You will find the installation files on the Internet (see

www.auerswald.de/service).

All subscribers that should be controlled over a PC must be configured for LAN-TAPI.

Note: If PBX Call Assist is switched on, all available TAPI lines will instead

be administrated by the corresponding UCServer server software.

Proceed as follows:

• Using the configuration manager

1. Open the page Functions > LAN TAPI.

3. In the Phone number list fields, select the subscribers in question.

COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016

Compact 5000r