Configuring Priority; Switching The Ringing Delay On/Off - Auerswald COMpact 5000 Operation Manual

In the case of a second call to the main group, it will be checked both for the
main group and for the subgroup whether splitting is possible (Split Group).
If this is the case, the subgroup will be considered for both calls and the
members of the subgroup will be divided among both calls.
With the variants Linear and Adding, a busy subscriber is skipped and the
next subscriber in line is called. With the setting rotating after the first loop
(all available telephones have been/are ringing once), the busy subscribers
hear the knocking tone - if allowed.
The alarm call delay time between alarm subscribers is independent of the
group ringing sequences. With the variants Linear and Adding, it is possible
that the last members of a group are not called because the next alarm
subscriber has already been called.
After a PBX reset/reboot, the priorities assigned in the configuration are used
for balancing.

Configuring Priority

If a ringer scheme with priority (see Please select a group:) was configured for the enabled
group, the requested order can be defined here.
Proceed as follows:
• Using the configuration manager
1. Open the page Groups > Properties > Basic settings.
2. In the Priority list field, select the required priorities in the lines of the corresponding
group members.

Switching the Ringing Delay On/Off

If for a member of a group with configured ringing sequence All the ringing delay is enabled, in
a group call this telephone rings after the configured Ringer delay time.
Proceed as follows:
• Using the configuration manager
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016
Functions
Ringing Sequence
Configuring Priority
393