Table of Contents
Advertisement
– Functions > Music on Hold/announcements > File assignment > Music on Hold/
Alarm
– Using a character string on the internal telephone (see section Short Reference)
• Configuring alarms.
– Using the configuration manager (page Devices > Alarms > Configure)
• Activating alarms.
– Using the configuration manager (page Devices > Alarms)
– Using a character string on the internal or external telephone (see section Short
Reference)
Confirming Alarms
An alarm can be signaled by the ringing of both an internal or an external telephone. To
terminate the complete alarm loop (and to switch off relays assigned to the alarm), the alarm
can be confirmed.
Requirements:
• DTMF-capable telephone or DTMF dialler
If an alarm is signaled at an internal or external telephone, proceed as follows:
1. Take off the receiver of the telephone on which the alarm is being signaled.
You will hear the announcement.
2. Within the next 60 seconds dial 0.
You will hear the confirmation tone.
Note: You can confirm the alarm already during the announcement. If you do
not confirm the alarm (or if you dial a wrong digit), you will hear the busy
signal and the call will be automatically terminated by the PBX. A further
alarm call may be initiated after some time if the other alarm subscribers do
not confirm the alarm.
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016
Functions
Alarm
Confirming Alarms
305
Advertisement
Table of Contents
