Switching Authorisation For Switching Of Relays On/Off - Auerswald COMpact 5000 Operation Manual

Functions
Relays (Actuators)

Switching Authorisation for Switching of Relays On/Off

Proceed as follows:
• Separately for relays
• Using the configuration manager
Requirements:
• Created analogue relay
1. Open the page Devices > Relays (Actuators).
2. Click Configure in the line for the corresponding relay.
3. Enter DTMF sequences required by the connected device in the Switch on and
Switch off entry fields. Possible entries:
Digits and the characters * and #
The comma ',' character as a pause of half a second
Switching Authorisation for Switching of Relays On/Off
If the authorisation for switching of relays is enabled, the subscriber in question can switch
relays manually.
Proceed as follows:
• Separately for subscribers
• Separately for configurations
• Using the configuration manager
Note: As described in the following, the setting is also possible via profiles
(Subscriber (scr.) > Profiles > Configuration > Configure > Auhtorisa-
tions). If the check box Profile-controlled settings has been selected, the
property set in the right-hand column will apply. For assignment of the profile,
see chapter Settings > Profiles.
1. Open the page Subscriber (scr.) > Properties > Authorisations.
2. In the list field at the top, select the subscriber in question by his name or number.
466
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016