Status Displays; Status Displays On The Leds - Auerswald COMpact 5000 Operation Manual

Status Displays

To control the operating state, the PBX provides various status displays.

Status Displays on the LEDs

Status LED:
Flashes red (50/50 ms)
Flashes red (0,5/0,5 s)
Flashes orange (50/50 ms)
Flashes orange (0,5/0,5 s)
Status LED:
Lit in red
Lit in orange
Lit in green
Lit in green
Lit in green
Lit in green
Status LED:
Flashes red (1/1 s)
Flashes orange (1/
1 s)
Note: If the Power LED remains constantly lit in red even after a restart, an
error has occured. Please contact your dealer or the manufacturer directly.
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016
User prompt:
Pressing the Software default button is detected.
The Software default button was pressed long enough.
Pressing the Software altern. button is detected.
The Software altern. button was pressed long enough.
Power LED:
Lit in red
Lit in red
Lit in red
Lit in orange
Flashes orange
Lit in green
Power LED:
Lit in red
Lit in red
PBX status (after restart):
The boot partition is being tested.
The kernel is being loaded from the partition.
The kernel is being initialised.
The kernel modules are being loaded.
The data base is being initialised/converted.
The PBX is ready for operation.
PBX status (in the case of an error):
No valid boot partition was found. System is
paused.
In both boot partitions no constant kernel data
were found. System is paused.
Service and Maintenance
Status Displays
Status Displays on the LEDs
741