Configuring The Syslog Server; Downloading Service Data - Auerswald COMpact 5000 Operation Manual

Pbx for analogue/isdn/internet telephony

Hide thumbs Also See for COMpact 5000:

Table of Contents

Further steps:

• The technical departments (Service and Development) can use this file to perform trouble-

shooting. If the cause of the error cannot be found in the protocol, your specialised dealer

or the Service Department will set additional categories and record an extended protocol.

Configuring the Syslog Server

A protocol can be recorded to log and display control and management information about the

connections to the PBX e.g. to display errors. You will thus be able to see the error type, and

maybe even its cause, from the list of transferred information.

Proceed as follows:

• Using the configuration manager

Requirements:

• Syslog server configured by the system administrator

• Knowledge of the IPv4 or IPv6 address and UDP port number of the syslog server

1. Open the page Administration > Logging.

2. In the Syslog server IP entry field, enter the IPv4 or IPv6 address of the syslog-

3. In the Syslog server port entry field, enter the UDP port number of the syslog server.

Logging of the connection data will start as soon as you have saved your settings.

If the PBX exhibits a malfunction which is not caused by incorrect operation or external influ-

ences, the service data can be used to diagnose the malfunction.

Note the following legal notes before saving the service data.

COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016

Service and Maintenance

Service Data

Configuring the Syslog Server

Compact 5000r