Table of Contents
Advertisement
Functions
Call Forwarding
Switching Group Call Forwarding Only for External Calls On/Off
The group property Call Restrictor settings of the subscribers functions
like No Call Restrictor for call forwarding for groups.
The group property Call Deblocker settings of the subscribers functions
like No Call Deblocker for call forwarding for groups.
The group property Exchange line authorisation of the subscribers
functions like International for call forwarding for groups.
The group property Telephone book authorisation of subscribers
functions like Telephone book authorisation of all group members like for
call forwarding for groups.
Preferred exchange line/Number Presentation: The number of the group is
always presented.
To avoid having to use a second call channel in the case of call forwarding to
an external destination, the PBX tries to reroute the call directly at the
network provider using call deflection. The following requirements must be
fulfilled for this purpose: 1. The incoming call was made via an ISDN network
provider supporting call deflection. 2. The rerouted phone number is neither
called as a group member, nor is it required to consider parallel calling or
fallback on busy.
Switching Group Call Forwarding Only for External Calls On/Off
If call forwarding for groups (unconditional, on busy, on no reply) is only performed for external
calls,only external calls will be forwarded.
Proceed as follows:
• Separately for groups
• Separately for configurations
• Using the configuration manager
Note: As described in the following, the setting is also possible via profiles (...
> Profiles > Configuration > Configure > ...). If the check box Profile-
controlled settings has been selected, the property set in the right-hand
column will apply. For assignment of the profile, see chapter Settings >
Profiles.
1. Open the following page:
490
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016
Advertisement
Table of Contents
