Update Status; Restoring The Firmware In Use Prior To The Firmware Update - Auerswald COMpact 5000 Operation Manual

Pbx for analogue/isdn/internet telephony

Hide thumbs Also See for COMpact 5000:

Table of Contents

Service and Maintenance

Firmware Update

Update Status

If an update of the PBX has been initiated from the update server, you can view the following

information on the Administration > Firmware update/restart page, in the Update status line

under Firmware update via update server:

• Update status: information about the update that is currently being performed. An error

message appears if the update encounters a problem

• Date of the last update attempt

• Date of the last successful update

Only the update status is displayed (during the update) for system telephone updates.

Note: When you open the page it first shows the status, which is automati-

cally updated every 30 seconds.

The PBX retains not only the current firmware but also the firmware previously used in the flash

memory. If necessary, the old firmware can be restored.

Caution: The PBX reboots automatically after you restore the previous

firmware. This interrupts all the connections with the web server, all the calls

and the data services. Unsaved data gets lost!

Proceed as follows:

• Using the configuration manager

• By clicking a button on the PBX

Using the Configuration Manager to Restore Firmware

Requirements:

• Firmware update, carried out

1. Open the page Administration > Firmware update/restart.

COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016

Compact 5000r