Table of Contents
Advertisement
Programming Model
Bit
Name
7
—
Reserved, should be cleared.
6
NPL
Non-pipelined mode. Determines whether the core operates in pipelined or mode or not.
0 Pipelined mode
1 Nonpipelined mode. The processor effectively executes one instruction at a time with no overlap. This
adds at least 5 cycles to the execution time of each instruction. Given an average execution latency of 1.6
cycles/instruction, throughput in non-pipeline mode would be 6.6 cycles/instruction, approximately 25%
or less of pipelined performance.
Regardless of the NPL state, a triggered PC breakpoint is always reported before the triggering instruction
executes. In normal pipeline operation, the occurrence of an address and/or data breakpoint trigger is
imprecise. In non-pipeline mode, triggers are always reported before the next instruction begins execution
and trigger reporting can be considered precise.
5
IPI
Ignore pending interrupts.
1 Core ignores any pending interrupt requests signalled while in single-instruction-step mode.
0 Core services any pending interrupt requests that were signalled while in single-step mode.
4
SSM
Single-step mode. Setting SSM puts the processor in single-step mode.
0 Normal mode.
1 Single-step mode. The processor halts after execution of each instruction. While halted, any BDM
command can be executed. On receipt of the
halts again. This process continues until SSM is cleared.
3–0
—
Reserved, should be cleared.
29.4.5 Data Breakpoint/Mask Registers (DBR, DBMR)
The DBR, shown in Figure 29-8, specifies data patterns used as part of the trigger into
debug mode. DBR bits are masked by setting corresponding DBMR bits, as defined in
TDR.
31
Field
Reset
R/W DBR is accessible in supervisor mode as debug control register 0x0E, using the WDEBUG instruction and through the
BDM port using the
DBMR is accessible in supervisor mode as debug control register 0x0F,using the WDEBUG instruction and via the
BDM port using the
DRc[4–0]
Figure 29-8. Data Breakpoint/Mask Registers (DBR/DBMR)
29-12
Table 29-8. CSR Field Descriptions (continued)
Data (DBR); Mask (DBMR)
and
commands.
RDMREG
WDMREG
command.
WDMREG
0x0E (DBR), 0x0F (DBMR)
MCF5282 User's Manual
Description
command, the processor executes the next instruction and
GO
Uninitialized
0
MOTOROLA
Advertisement
Table of Contents
