Fast Termination Cycles; Read Cycle With Fast Termination; Write Cycle With Fast Termination - Motorola ColdFire MCF5281 User Manual

Motorola microcontroller user's manual
Table of Contents

Advertisement

13.4.5 Fast Termination Cycles

Two clock cycle transfers are supported on the MCF5282 bus. In most cases, this is
impractical to use in a system because the termination must take place in the same
half-clock during which TS is asserted. As this is atypical, it is not referred to as the
zero-wait-state case but is called the fast-termination case. Fast termination cycles occur
when the external device or memory asserts TA less than one clock after TS is asserted.
This means that the MCF5282 samples TA on the rising edge of the second cycle of the bus
transfer. Figure 13-9 shows a read cycle with fast termination. Note that fast termination
cannot be used with internal termination.
CLKOUT
A[31:0], SIZ[1:0]
R/W
TIP
TS
CSn, BSn, OE
D[31:0]
TA
Figure 13-9. Read Cycle with Fast Termination
Figure 13-10 shows a write cycle with fast termination.
CLKOUT
A[31:0], SIZ[1:0]
R/W
TIP
TS
CSn, BSn
D[31:0]
TA
Figure 13-10. Write Cycle with Fast Termination
MOTOROLA
S0
S1
Read
S0
S1
Chapter 13. External Interface Module (EIM)
Data Transfer Operation
S4
S5
S4
S5
Write
13-9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Coldfire mcf5282

Table of Contents