Table of Contents
Advertisement
Bits
31-2
1
0
17.5.4.6 MII Management Frame Register (MMFR)
The MMFR is accessed by the user and does not reset to a defined value. The MMFR
register is used to communicate with the attached MII compatible PHY device(s),
providing read/write access to their MII registers. Performing a write to the MMFR will
cause a management frame to be sourced unless the MSCR has been programmed to 0. In
the case of writing to MMFR when MSCR = 0, if the MSCR register is then written to a
non-zero value, an MII frame will be generated with the data previously written to the
MMFR. This allows MMFR and MSCR to be programmed in either order if MSCR is
currently zero.
31
30
Field
ST
Reset
R/W
15
Field
Reset
R/W
Address
Figure 17-9. MII Management Frame Register (MMFR)
MOTOROLA
Table 17-16. ECR Field Descriptions
Name
—
Reserved.
ETHER_EN
When this bit is set, the FEC is enabled, and reception and
transmission are possible. When this bit is cleared, reception is
immediately stopped and transmission is stopped after a bad CRC
is appended to any currently transmitted frame. The buffer
descriptor(s) for an aborted transmit frame are not updated after
clearing this bit. When ETHER_EN is deasserted, the DMA, buffer
descriptor, and FIFO control logic are reset, including the buffer
descriptor and FIFO pointers. The ETHER_EN bit is altered by
hardware under the following conditions:
• ECR[RESET] is set by software, in which case ETHER_EN will
be cleared
• An error condition causes the EIR[EBERR] bit to set, in which
case ETHER_EN will be cleared
RESET
When this bit is set, the equivalent of a hardware reset is
performed but it is local to the FEC. ETHER_EN is cleared and all
other FEC registers take their reset values. Also, any
transmission/reception currently in progress is abruptly aborted.
This bit is automatically cleared by hardware during the reset
sequence. The reset sequence takes approximately 8 system
clock cycles after RESET is written with a 1.
29
28
27
OP
Chapter 17. Fast Ethernet Controller (FEC)
Description
23
PA
Undefined
R/W
DATA
Undefined
R/W
IPSBAR + 0x1040
Programming Model
22
18 17
RA
16
TA
0
17-29
Advertisement
Table of Contents
