11-110 Paper Remains at Decurler Exit Sensor Long RAP
The Control Logic detected that paper remained on the Decurler Exit Sensor at power on.
Initial Actions
•
Refer to BSD12.6 for the following procedure.
•
Ensure that no paper is blocking the Decurler Exit sensor
•
Ensure that
P/J651
and
P/J654
Decurler Exit Sensor are connected before beginning this RAP.
Procedure
Enter dC330 012-145 Decurler Exit Sensor. Press Start. The display is H.
Y
N
Go to
Flag
9,
Flag
10, and
Flag 11
If the harness is good, replace the Decurler Exit Sensor
ues, replace the Decurler PWB
(PL
+5VDC is measured between P/J654-2 and GND on the Decurler PWB.
Y
N
Replace the Decurler Exit Sensor
(PL
Check the Decurler Exit Sensor for intermittent operation. If the sensor is good, Replace the
Decurler PWB
(PL
18.6).
Finisher/Sorter
11-110 Paper Remains at Decurler Exit Sensor Long
on the Decurler Control PWB, and
P/J658
on BSD12.6 and check the harness for a short circuit.
(PL
18.6). If the problem contin-
18.6).
18.6).
11-111 Paper Remains at Decurler Exit Sensor Short RAP
The Control Logic detected that paper remained on the Decurler Exit Sensor at power on.
Initial Actions
•
Refer to BSD12.6 for the following procedure.
•
Ensure that no paper is blocking the Decurler Exit sensor
on the
•
Ensure that
P/J651
and
Decurler Exit Sensor are connected before beginning this RAP.
Procedure
Enter dC330 012-145 Decurler Exit Sensor. Press Start. The display is H.
Y
N
Go to
Flag
9,
Flag
10, and
If the harness is good, replace the Decurler Exit Sensor
ues, replace the Decurler PWB
+5VDC is measured between P/J654-2 and GND on the Decurler PWB.
Y
N
Replace the Decurler Exit Sensor
Check the Decurler Exit Sensor for intermittent operation. If the sensor is good, Replace the
Decurler PWB
(PL
18.6).
1/05
8d-10
manuals4you.com
manuals4you.com
P/J654
on the Decurler Control PWB, and
Flag 11
on BSD12.6 and check the harness for a short circuit.
(PL
18.6). If the problem contin-
(PL
18.6).
(PL
18.6).
DocuColor 12/DCCS50
P/J658
on the
Reissue