Single Catch Tray (Sct) Assembly - Xerox DocuColor 12/DCCS50 Service Manual

2. Route the Finisher Drive Belt onto the gears per the illustration
Figure 2 Install the Finisher Drive Belt
3. Reinstall the belt idler bracket.
4. Reinstall the E-clip and the gear.
5. Reinstall the bracket with the motor.
NOTE: In the following step, ensure that the wires are secured away from belts, pulleys,
and all moving components.
6. Reinstall the wire harnesses into the harness holders and reconnect the connector
J1084.
Finisher/Sorter
REP 15.1.16, REP 15.1.17
REP 15.1.17 Single Catch Tray (SCT) Assembly
(Figure 2).
Parts List on
Removal
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the Machine Power Cord.
1. Remove the Rear Upper Cover
2. Remove the Single Catch Tray (SCT) Assembly
1.
2.
3.
4.
5.
P/
Replacement
Reinstall the Single Catch Tray (SCT) Assembly in the reverse order of disassembly.
1/05
8d-74
manuals4you.com manuals4you.com
PL 18.3
WARNING
(REP 15.3.7).
Remove the SCT Exit Cover.
Remove one screw from the bottom of the tray.
Lift up the tray, tilt out, and move the tray slightly away from the Finisher.
Disconnect the sensor connector.
Disengage the wire harness from the harness holders on the tray and remove the
tray.
Figure 1 Remove the Single Catch Tray (SCT) Assembly
(Figure 1).
Reissue
DocuColor 12/DCCS50