3-319 Finisher/Sorter Communication Failure RAP
The 3-319 Fault Code indicates a communication failure between the IOT PWB and the Fin-
isher PWB.
Initial Actions
Refer to BSD12.4 PWB Communications (Finisher) and to BSD 12.7, Monitoring, in this proce-
dure.
Procedure
PO/PO the machine. Fault Code 3-319 is still declared.
Y
N
If an intermittent is suspected, perform the following:
•
Check the connections to the IOT CPU PWB and the Finisher PWB, and the inter-
connecting harness
•
Reseat
P/J405
at the IOT CPU PWB, P/J1027, and
and P880, the Double Plug
Check for +5 VDC at P/J1026-3. +5 VDC is measured at P/J1026-2 on the Finisher PWB.
Y
N
Perform the following:
•
Go to +5VDC Wire Nets and check for an open/short circuit
•
Go to the
+5 VDC Power (IOT LVPS) RAP
Check for +24 VDC at P/J1026-1 on the Finisher PWB. +24 VDC is measured at
4.
Y
N
Perform the following:
•
Go to +24VDC-1 Wire Net and check for an open/short circuit
•
Go to the
+24 VDC Power (IOT LVPS) RAP
Perform the following:
•
Go to
Flag 1
on BSD 12.4, and check the following wires for an open/short circuit:
–
Check the wire between Mailbox Control PWB P/J1027-1 and IOT CPU PWB
J405-1
–
Check the wire between Mailbox Control PWB P/J1027-2 and IOT CPU PWB
J405-2
–
Check the wire between Mailbox Control PWB P/J1027-3 and IOT CPU PWB
J405-3
–
Check the wire between Mailbox Control PWB P/J1027-4 and IOT CPU PWB
J405-4
•
Replace the Finisher PWB
(PL
18.4)
•
Replace the IOT CPU PWB
(PL
9.2)
Reissue
DocuColor 12/DCCS50
P/J1026
at the Finisher PWB,
P/J1026
-
P/
P/
P/
P/
1/05
8d-3
3-319 Finisher/Sorter Communication Failure RAP
Finisher/Sorter