Paper Remains On V-Tra In Sensor Rap - Xerox DocuColor 12/DCCS50 Service Manual

H
Y N
+5 VDC is measured between P/J651-3 and P/J651-4 on the Finisher PWB.
Y N
+5 VDC is measured between P/J1028-3 and P/J1028-4 on the Finisher
PWB.
Y N
+5 VDC is measured between P/J880-3 and P/J880-2.
Y N
Go to the +5VDC
short circuit.
Go to Flag 17 on BSD 12.1 and check the harness for an open circuit.
Replace the Finisher PWB
Replace the Decurler Exit Sensor
Go to Flag 9 on BSD12.6. Check the wire for an open circuit. If the wires are good,
replace the Decurler Exit Sensor (PL
More than +4.5 VDC is measured between P/J658-2 and GND on the Decurler Exit Sen-
sor.
Y N
Replace the Decurler Exit Sensor (PL
Check the following parts for wear, glazing, or slipping.
• Mailbox Entrance Roll (PL 18.10)
• Pinch Rollers (PL 18.12)
• SCT Exit Roll (PL 18.10)
• Drive Belt (PL 18.10)
• Drive gears (PL 18.7) (PL 18.8)
Reissue
DocuColor 12/DCCS50
Figure 1 wirenets and check wires for an open or
(PL 18.4).
(PL 18.6).
18.6).
18.6).

11-190 Paper Remains on V-Tra In Sensor RAP

The Control Logic detected that paper remained on the V-Tra In Sensor at power on.
Initial Actions
• Refer to BSD12.7 and BSD12.17 for the following procedure.
• Ensure that no paper is blocking the V-Tra In sensor and the sensor actuator moves freely.
• Check for any obstructions in the paper path.
• Ensure that P/J1040 on the Finisher PWB,
Mailbox Entrance Sensor are connected before beginning this RAP.
Procedure
Enter dC330 012-142 Mailbox Entrance Sensor. Press Start. The display is L.
Y N
Go to Flag 7 and Flag 8 on BSD12.7 and check the harness for a short circuit. If the har-
ness is good, replace the Mailbox Entrance Sensor
replace the Finisher PWB (PL 18.4).
More than +4.3 VDC is measured between P/J1040-4 and GND on the Finisher PWB.
Y N
Replace the Mailbox Entrance Sensor
Check the Mailbox Entrance Sensor for intermittent operation. If the sensor is good, Replace
the Finisher PWB (PL 18.4).
1/05
11-146 Decurler Exit Sensor On Jam Short RAP, 11-
8d-21
P/J1076 double plug, and P/J1017
(PL 18.13). If the problem continues,
(PL 18.13).
Finisher/Sorter
on the