End Wall Open Sensor - Xerox DocuColor 12/DCCS50 Service Manual

REP 15.2.14 End Wall Open Sensor
Parts List on PL 18.16
Removal
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Disconnect the Finisher from the Printer.
3. Remove the Stapler Cover Assembly
4. Remove the Rear Lower Cover (REP
5. Remove the Stacker Tray Assembly
6. Remove the screws (4) securing the Tie Plate to the Finisher frame
the Tie Plate.
7. Remove the End Wall Open Sensor
1. Remove the screw (1) securing the Compiler Paper Sensor Bracket to the Compiler.
Remove the Bracket along with the Compiler Paper Sensor.
2. Disconnect P/J1046 from the Sensor.
3. Press in and release the Sensor latches that are securing the Sensor to the Bracket.
Remove the Sensor.
Figure 1 Remove the End Wall Open Sensor
Replacement
1. Reconnect P/J1046 to the Sensor.
Finisher/Sorter
REP 15.2.14
WARNING
(REP 15.3.3).
15.3.15).
(REP 15.2.2).
(Figure
(Figure 1).
2. Position the End Wall Open Sensor into the Sensor cutout in the Sensor Bracket.
3. Reinstall the Tie Plate and use the screws (4) to secure it to the frame.
4. Reinstall the Stacker Tray Assembly.
5. Reinstall the Rear Lower Cover.
6. Reinstall the Stapler Cover Assembly.
7. Connect the Finisher to the Printer.
1). Remove
1/05
8d-90
manuals4you.com manuals4you.com
Reissue
DocuColor 12/DCCS50