Hcf Feed Belt; Hcf Feed/Nudger/Retard Rolls - Xerox DocuColor 12/DCCS50 Service Manual

REP 2.8.37 HCF Feed Belt
Parts List on PL 15.10
Removal
To avoid electrical shock, switch-OFF the Main Power Switch and disconnect the Power
Cord.
1. Remove the HCF Paper Tray Assembly
2. Remove the HCF Rear Cover (PL 15.10).
3. Remove the HCF Feed Belt (Figure
2. Remove KL-clip and Pulley
1. Remove the KL-clip and Feed Clutch
Figure 1 Removing the Feed Belt
Replacement
NOTE: Place the Feed Belt on the Pulley before replacing the Drive Motor.
NOTE: Do not over tension the Feed Belt. The tension produced by the spring is sufficient.
1. Reverse the above procedures to replace the Feed Belt.
High Capacity Feeder
REP 2.8.37, REP 2.8.38
WARNING
(REP 2.7.5).
1).
3. Remove Drive Motor
and Mounting Bracket as
one (4 screws)
4. Remove Feed Belt
REP 2.8.38 HCF Feed/Nudger/Retard Rolls
Parts List on PL 15.14
Removal
To avoid electrical shock, switch-OFF the Main Power Switch and disconnect the Power
Cord.
1. Remove the HCF Paper Tray Assembly
2. Remove the HCF Feed/Nudger/Retard Rolls
NOTE: The Front Chute must be removed to allow clearance to remove the Feed Roll.
Rolls are identical and interchangeable.
Nudger Roll
Retard Roll
Figure 1 Removing the Feed/Nudger/Retard Rolls
Replacement
1. Reverse the above procedures to replace the Rolls.
1/05
8a-24
manuals4you.com manuals4you.com
WARNING
(REP 2.7.5).
(Figure 1).
Feed Roll
Front Chute
Push the Lock
Tab and slip Roll
off shaft (3)
DocuColor 12/DCCS50
Reissue