Finisher Pwb; Finisher Pwb Eprom - Xerox DocuColor 12/DCCS50 Service Manual

REP 15.3.28 Finisher PWB
Parts List on PL 18.4
Removal
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Roll the Finisher away from the printer until it stops.
3. Remove the Left Lower Cover (REP
NOTE: Observe the ESD procedures while removing the Finisher PWB.
4. Remove the Finisher PWB (Figure
1. Remove the Finisher PWB Cover.
2. Disconnect the 18 connectors from the Finisher PWB. Remove the harness from the
harness holder and move the harness lines away.
3. Remove eight screws securing the Finisher PWB.
4. Grasp the PWB at the bottom and move the bottom away first to remove the Finisher
PWB.
Replacement
1. Reinstall the Finisher PWB in the reverse order of removal.
Figure 1 Remove the Finisher PWB
Finisher/Sorter
REP 15.3.28, REP 15.3.29
WARNING
15.3.6).
1).
REP 15.3.29 Finisher PWB EPROM
Parts List on PL 18.4
Removal
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Observe the ESD procedures.
3. Remove the Finisher PWB
4. Remove the EPROM.
Replacement
1. Reinstall the EPROM in the reverse order of removal.
1/05
8d-126
manuals4you.com manuals4you.com
WARNING
(REP 15.3.28).
DocuColor 12/DCCS50
Reissue