Stacker Offset Home Sensor - Xerox DocuColor 12/DCCS50 Service Manual

REP 15.2.18 Stacker Offset Home Sensor
Parts List on PL 18.19
Removal
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Remove the Rear Lower Cover (REP
3. Remove the Stacker Offset Home Sensor
1. Remove the screws (2) securing the Offset Home Sensor Bracket to the Finisher
frame, and remove the Bracket.
2. Free the two wire harnesses from the wire clamp that is attached to the Bracket. Dis-
connect P/J1051 from the Stacker Offset Home Sensor.
3. Press in and release the Sensor latches that secure the Sensor to the Bracket, and
remove the Sensor.
Figure 1 Remove the Stacker Offset Home Sensor
Replacement
1. Position the Stacker Offset Home Sensor into the cutout in the Sensor Bracket.
2. Reconnect P/J1051 to the Stacker Offset Home Sensor.
3. Secure the two wire harnesses in the wire clamp that is attached to the Bracket.
4. Reinstall the Stacker Offset Home Sensor Bracket onto the Finisher frame. Use two
screws to secure the Bracket to the frame.
Finisher/Sorter
REP 15.2.18
WARNING
15.3.15).
(Figure 1).
5. Reinstall the Rear Lower Cover.
1/05
8d-94
manuals4you.com manuals4you.com
Reissue
DocuColor 12/DCCS50