Table of Contents
Advertisement
11-191 Paper Remains at Mailbox Vertical Sensor / 1 Bin
Sensor RAP
The Control Logic detected that paper remained on the Mailbox Vertical Sensor at power on.
Initial Actions
•
Refer to BSD12.8 for the following procedure.
•
Ensure that no paper or foreign object is blocking the Mailbox Vertical sensor.
•
Ensure that the Mailbox Vertical sensor and the Vertical LED are clean.
•
Ensure that
P/J1004
on the Finisher PWB, and
Vertical Sensor are connected before beginning this RAP.
Procedure
Enter dC330 012-115 Vertical Sensor. Press Start. The display is L.
Y
N
+5 VDC is measured between P/J1004-3 and P/J1004-1 on the Mailbox PWB.
Y
N
+5 VDC is measured between P/J1025-3 and P/J1025-4 on the Mailbox PWB.
Y
N
+5 VDC is measured between P/J1029-3 and P/J1029-4 on the Finisher
PWB
Y
N
Go to the +5 VDC wirenet and troubleshoot the wires between P/J1029-1
and P/J44-22 on the Distribution PWB.
Replace the Finisher PWB
Replace the Mailbox PWB
(PL
Go to
Flag 19
and
Flag 20
on BSD12.8. Check the harness for an open circuit. If the har-
ness is good, replace the Vertical LED
Less than +0.5 VDC is measured between P/J1004-3 and DC COM on the Mailbox PWB.
Y
N
Replace the Mailbox Vertical Sensor
Check the Mailbox Vertical Sensor for intermittent operation. If the sensor is good, Replace the
Mailbox PWB
(PL
18.11).
Finisher/Sorter
11-191 Paper Remains at Mailbox Vertical Sensor / 1
P/J1023
and
P/J1024
on the Mailbox
(PL
18.4)
18.11).
(PL
18.13).
(PL
18.13).
11-192 Paper Remains at SCT Exit Sensor RAP
The Control Logic detected that paper remained on the SCT Exit Sensor at power on.
Initial Actions
•
Refer to BSD12.10 for the following procedure.
•
Ensure that no paper is blocking the SCT Exit sensor and the sensor actuator moves
freely.
•
Check for excessive static on copies.
•
Check for any obstructions in the paper path.
•
Ensure that
P/J1040
on the Mailbox PWB, and
are connected before beginning this RAP.
Procedure
Enter dC330 012-107 SCT Entrance Sensor. Press Start. The display is L.
Y
N
Replace the Finisher PWB
+5VDC is measured between P/J1040-1 and GND on the Mailbox PWB.
Y
N
Go to
Flag 3
on BSD12.10 and check the harness for a short circuit. If the harness is
good, replace the SCT Exit Sensor
If the problem is intermittent, ensure that the SCT Exit Sensor is clean. If the problem contin-
ues, go to
Flag 2
and
Flag 3
on BSD12.10 and check for loose connectors or crimped wires. If
the problem continues, replace the SCT Exit Sensor
1/05
8d-22
manuals4you.com
manuals4you.com
P/J1017
on the Mailbox Entrance Sensor
(PL
18.4).
(PL
18.13).
(PL
18.13).
DocuColor 12/DCCS50
Reissue
Advertisement
Table of Contents
Troubleshooting
