Table of Contents
Advertisement
11-921 SCT Tray Full Stack RAP
The Control Logic detected that the SCT Tray is full.
Initial Actions
•
Refer to BSD12.10 for the following procedure.
•
Ensure that the SCT Tray is empty
•
Ensure that connectors
P/J1040
on the Finisher PWB, Shorting Plug P/J1080, and
J1079
on the SCT Full Sensor are seated correctly and there are no obvious crimped or
broken wires.
Procedure
Enter dC330 012-275 SCT Full Sensor. Press Start. The display is H.
Y
N
+5 VDC is measured between P/J1040-6 and DC-COM on the Finisher PWB.
Y
N
Go to
Flag 4
on BSD12.10. Check the wire for a short circuit to ground. If the wire is
good, replace the SCT Full Sensor
Replace the Finisher PWB
(PL
18.4).
Block the SCT Full Sensor with a sheet of paper. The display changes to L.
Y
N
+5VDC is measured between P/J1079-1 and P/J1079-3 on the SCT Full Sensor.
Y
N
+5 VDC is measured between P/J1040-7 and P/J1040-5 on the Finisher PWB.
Y
N
+5 VDC is measured between P/J880-3 and P/J880-2.
Y
N
Go to the +5VDC
Figure 1
circuit.
Check the wires between
Finisher PWB. If the wires are OK, replace the Finisher PWB
Go to
Flag 1
and
Flag 4
on BSD12.10. Check the harness for an open or a short cir-
cuit. If the harness is good, replace the SCT Full Sensor
Go to
Flag 4
and check for an open or short circuit. If the problem continues, replace the
SCT Full Sensor
(PL
18.3).
Check the SCT Full Sensor for intermittent operation, If the problem continues, replace the
SCT Full Sensor
(PL
18.4).
Finisher/Sorter
11-921 SCT Tray Full Stack RAP, 11-922 Sorter Stack-
(PL
18.3).
wirenets and check wires for an open or short
P/J44
on the Distribution PWB and
P/J1026
(PL
18.4).
(PL
18.3).
11-922 Sorter Stacker Full RAP
The Control Logic has determined that bin 10 is full while operating in the Stack Mode.
Initial Actions
Ensure that there are no obstructions in the Stacker area
Procedure
P/
Go to
11-921 SCT Tray Full Stack RAP
on the
1/05
8d-32
manuals4you.com
manuals4you.com
to check out the SCT Full Sensor for any malfunctions.
DocuColor 12/DCCS50
Reissue
Advertisement
Table of Contents
Troubleshooting
