Finisher Transport Roll 2 - Xerox DocuColor 12/DCCS50 Service Manual

Figure 1 Remove the Transport Roll 1
Reissue
DocuColor 12/DCCS50
REP 15.1.22 Finisher Transport Roll 2
Parts List on PL 18.9
Removal
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the Machine Power Cord.
1. Remove the Rear Upper Cover
2. Remove the Rear Lower Cover
3. Remove the MailBox Door Assembly
4. Remove the Transport Roll 2
1. Remove the E ring and Collar from the Idler Pulley that is being driven by the Fin-
isher Transport Roll 2.
2. Remove the E ring, Idler Pulley and Bearing from the rear of the Finisher Transport
Roll shaft.
3. Remove the E ring and Bearing from the front of the Finisher Transport Roll 2 shaft.
4. Remove the screws (4) securing the Entrance Lower Chute to the frame
item 25). Do not remove the Entrance Lower Chute. This will provide enough room
to allow the Finisher Transport Roll 2 shaft to be removed.
5. Remove the Finisher Transport Roll 2 from the front of the Finisher.
Replacement
1. Install the Finisher Transport Roll 2 into the Finisher frame.
2. Install the Bearing and E ring onto the front end of the Finisher Transport Roll 2 shaft.
3. Install the Bearing, Idler Pulley, and E ring onto the rear of the Finisher Transport Roll 2
shaft. Ensure the Finisher Drive Belt is installed on the Pulley.
4. Reinstall the Entrance Lower Chute to the frame using the screws (4).
5. Install the Collar and E ring on the Idler Pulley that is driven by the Finisher Transport Roll
2.
6. Install the Rear Upper Cover.
7. Install the Rear Lower Cover.
8. Install the Mailbox Door Assembly.
9. Install the Stapler Cover.
1/05
8d-77
WARNING
(REP 15.3.7).
(REP 15.3.15).
(REP 15.3.5).
(Figure 1).
REP 15.1.21, REP 15.1.22
(PL 18.14
Finisher/Sorter