Tamper Motor Drive Belt - Xerox DocuColor 12/DCCS50 Service Manual

REP 15.2.15 Tamper Motor Drive Belt
Parts List on PL 18.16
Removal
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Lower the Stacker Elevator so the Stacker Tray is at the lowest possible position.
3. Disconnect the Finisher from the Printer.
4. Remove the Stapler Cover Assembly
5. Remove the Rear Lower Cover (REP
6. Remove the Stacker Tray Assembly
7. Remove the screws (4) securing the Tie Plate to the Finisher Frame. Remove the Tie
Plate.
8. Remove the Tamper Motor (REP 15.2.11).
9. Remove the Tamper Motor Drive Belt
1. Loosen, do not remove, the screw (1) on the Belt Holder, and slip the Belt out of the
holder.
2. Loosen the screw that secures the Belt Tension Pulley.
3. Slip the Belt off of the Tension Pulley, and remove the Belt.
Figure 1 Remove the Tamper Motor Drive Belt
Reissue
DocuColor 12/DCCS50
WARNING
(REP 15.3.3).
15.3.15).
(REP 15.2.2).
(Figure 1).
Replacement
1. Position the Tamper Motor Drive Belt so the ribs are on the inside of the Belt loop.
2. Slip the Belt over the Tension Pulley.
3. Insert the Belt between the top and bottom of the Belt Holder, and tighten the screw on
the Belt Holder.
4. Reinstall the Tamper Motor.
5. Tighten the Belt Tension Screw.
6. Reinstall the Tie Plate and use the screws (4) to secure it to the frame.
7. Reinstall the Stacker Tray Assembly.
8. Reinstall the Rear Lower Cover.
9. Reinstall the Stapler Cover Assembly.
10. Connect the Finisher to the Printer.
1/05
8d-91
Finisher/Sorter
REP 15.2.15