Compiler Paddle Shaft Assembly - Xerox DocuColor 12/DCCS50 Service Manual

Replacement
1. Reinstall the Exit Roll.
2. Reinstall the Exit Roll front and rear bearings into the bearing cutouts at the front and rear
of the finisher frame. Use an E-ring at both ends of the Shaft.
3. Reinstall the Exit Shaft Pulley onto the Exit Shaft, and use one screw to secure the Pulley
to the Shaft.
4. Ensure the Transport Motor Drive Belt is properly installed on all pulleys.
5. Loosen the screws that secures the Belt Tension Assembly.
6. Allow the assembly to properly tension the belt, then tighten the two screws.
7. Reinstall the Paddle Shaft Drive Gear and use the E-ring to secure the Gear to the Shaft.
8. Reinstall the Upper Exit Chute Assembly.
9. Reinstall the Eject Pinch Roll Assembly.
10. Reinstall the Compiler Cover Assembly.
11. Reinstall the Rear Lower Cover.
12. Reinstall the Stapler Cover Assembly.
Finisher/Sorter
REP 15.2.25, REP 15.2.26
REP 15.2.26 Compiler Paddle Shaft Assembly
Parts List on PL 18.14
Removal
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Remove the Stapler Cover Assembly
3. Remove the Rear Lower Cover
4. Remove the Compiler Cover Assembly
5. Remove the Eject Pinch Roll Shaft Assembly
6. Remove the Upper Exit Chute Assembly
7. Remove the Exit Roll (REP
8. Remove the Compiler Paddle Shaft Assembly
1. Remove the E-ring securing the rear bearing to the Paddle Drive Shaft, and slide the
bearing off the Shaft.
2. Remove the screws (2) securing the Lower Exit Chute Assembly to the rear of the
Finisher frame.
3. Remove the screws (2) securing the Lower Exit Chute Assembly to the front of the
Finisher frame.
4. Remove the Lower Exit Chute Assembly and place it on a stable work surface.
5. Remove the E-rings from both ends of the Paddle Shaft.
6. Slide the Paddle Drive Belt off of the Paddle Drive Pulley.
7. Slide the Paddle Drive Pulley off of the Paddle Shaft.
8. Remove the screw securing the front Paddle Bearing, and slide the bearing off of the
Shaft.
9. Remove the screw securing the rear Paddle Bearing, and remove the bearing, Drive
Belt, Drive Shaft, and Paddle Shaft from the Lower Exit Chute Assembly.
10. Slide the Paddle Shaft out of the rear bearing.
1/05
8d-102
manuals4you.com manuals4you.com
WARNING
(REP 15.3.3).
(REP 15.3.15).
(REP 15.2.22).
(REP 15.2.23).
(REP 15.2.24).
15.2.21).
(Figure 1).
DocuColor 12/DCCS50
Reissue