Eject Clamp Sensor - Xerox DocuColor 12/DCCS50 Service Manual

REP 15.2.17 Eject Clamp Sensor
Parts List on PL 18.19
Removal
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Remove the Rear Lower Cover (REP
3. Remove the Eject Clamp Sensor (Figure
1. Remove the wire harnesses from the wire clamps that are attached to the Eject
Bracket.
2. Remove the screw (1) securing the Eject Clamp Sensor Bracket to the Eject Bracket,
and remove the Sensor Bracket, along with Sensor.
3. Disconnect P/J1054 from the Sensor.
4. Press in and release the Sensor latches that secure the Sensor to the Bracket, and
remove the Sensor.
Figure 1 Remove the Eject Clamp Sensor
Replacement
1. Position the Eject Clamp Sensor into the Eject Clamp Sensor Bracket.
2. Reconnect P/J1054 to the Sensor.
3. Reinstall the Eject Clamp Sensor Bracket onto the Eject Bracket. Use the screw (1) to
secure the Sensor Bracket.
Reissue
DocuColor 12/DCCS50
WARNING
15.3.15).
1).
4. Reinstall the wire harnesses to the wire clamps that are attached to the Eject Bracket.
5. Reinstall the Rear Lower Cover.
1/05
8d-93
Finisher/Sorter
REP 15.2.17