Router Rip; Routing Information Protocol (Rip) Commands; Enable (Rip); Ip Rip - Planet Networking & Communication WGS3-24000 User Manual

12.8 Routing Information Protocol (RIP) Commands

This section describes the commands you use to view and configure RIP, which is a distance-vector routing protocol that you
use to route traffic within a small network.

12.8.1 router rip

Use this command to enter Router RIP mode.
▫
Format router rip
▫
Mode Global Config

12.8.2 enable (RIP)

This command resets the default administrative mode of RIP in the router (active).
▫
Default enabled
▫
Format enable
▫
Mode Router RIP Config
no enable (RIP)
This command sets the administrative mode of RIP in the router to inactive.
▫
Format no enable
▫
Mode Router RIP Config

12.8.3 ip rip

This command enables RIP on a router interface.
▫
Default disabled
▫
Format ip rip
▫
Mode Interface Config
no ip rip
This command disables RIP on a router interface.
▫
Format no ip rip
▫
Mode Interface Config
12.8.4 auto-summary
This command enables the RIP auto-summarization mode.
478