Update Caller Id Setting; Update Caller Id During A Call; Boot Sequence Recovery Mode - Mitel 6867i Administrator's Manual

On the transferor phone, the REFER request will always be sent to the transferee.
IGNORING PAI HEADER FOR SEMI-ATTENDED TRANSFERS
In previous releases, when used in conjunction with the Mitel Clearspan call manager and a
remote phone was defined with an overriding caller ID, semi-attended transfers to the remote
phones would be sent to the destinations of the overriding caller ID and not the intended remote
phones. Administrators utilizing the phones with the Mitel Clearspan platform can correct this
by defining the "sip refer-to from contact" parameter as "1" (i.e. enabled) in the respective
configuration files. When enabled, the phone will check the user name from the contact header
received in 180 response and:
• if the contact header has user name, blind transfer the call to the user name
or
• if there is no contact header found or the contact header has no user name, put the remote
address of the original INVITE to the Refer-To header.
CONFIGURING SIP SETTINGS FOR SEMI-ATTENDED TRANSFERS
CONFIGURATION FILES
For the specific parameters you can set in the configuration files for customizing the
semi-attended transfer method, see Appendix A, the section,
Settings"" on page A-274.

UPDATE CALLER ID DURING A CALL

It is possible for a proxy or call server to update the Caller ID information that displays on the
phone during a call, by modifying the SIP Contact header in the re-INVITE message. The phone
displays the updated name and number information contained within the Contact header.
The following parameter allows the system administrator to enable or disable this feature:
• sip update callerid
This parameter is configurable via the configuration files only.
CONFIGURING UPDATE CALLER ID DURING A CALL
CONFIGURATION FILES
For the specific parameter you can set in the configuration files for enabling/disabling the update
of caller ID during a call, see Appendix A, the section,

BOOT SEQUENCE RECOVERY MODE

You can force the IP phone into recovery mode by pressing the 1 and # keys during boot up
when the logo displays. This feature is enabled by default on the IP phone.
You can disable this feature using the following parameter in the configuration files:
Advanced Operational Features
""Semi-Attended Transfer

"Update Caller ID Setting"

on page A-275.
6-11