Mitel 6867i Administrator's Manual page 666

Mitel 6800 Series SIP Phone Release 4.2.0 Administrator Guide
• auto resync max delay - Specifies the maximum time, in minutes, the phone waits past
the scheduled time before starting a checksync.
• auto resync days - Specifies the amount of days that the phone waits between checksync
operations.
In the Mitel Web UI, you can set the following parameters at the path Advanced
Settings->Configuration Server->Auto-Resync:
• Mode
• Time (24 hours)
• Maximum Delay
• Days
Setting the "auto resync max delay" (Maximum Delay) and "auto resync days" (Days)
parameters can greatly reduce the load placed on the configuration server when downloading
configurations.
RELOADING OF DIRECTORY FILES DURING AN AUTO-RESYNC
During an auto-resync, the IP phones have the ability to initiate a comparison of its local directory
files with those located on the configuration server and automatically update the local directory
files if changes are detected
If the auto-resync mode is set to" Configuration Files (1)" or "Both (3)", either through the IP
phone's Web UI or configuration files, when the phone reaches the configured auto-resync
date/time, the phone will perform a comparison on the directory files and trigger a reboot if
differences are found.
If the auto-resync mode is set to "None (0)" or "Firmware Info (2)" and the phone reaches the
configured auto-resync date/time, the directory files will not be checked.
Note: Irrespective of the auto-resync feature, if the phone receives a check-sync
NOTIFY, the directory file comparison will be performed and the applicable files will be
automatically updated as required.
8-7