Mitel 6867i Administrator's Manual page 251

2. In the "Autodial Number" field, specify the SIP number that the IP phone dials whenever
the IP phone is off-hook. An empty (blank) value disables autodial on the phone.
For example: 8500
3. In the "Autodial Timeout" field, specify a value, in seconds, for the timer as follows:
• If you want the IP phone to autodial the number immediately (hotline) whenever the IP
phone is off-hook, accept the default value of 0.
• If you want to specify a length of time for the IP phone to wait before dialing the number,
enter the length of time (in seconds). For example: 30
Valid values are 0 to 120.
4. Click Save Settings to save your changes.
Per-Line Configuration:
1. Click on Advanced Settings->Line N ->Autodial Settings.
2. Perform one of the following actions:
• To allow this line to use the global autodial settings, click on the Use Global Settings
parameter to enable it, then click Save Settings to save your changes.
• To specify a different autodial configuration for this specific line, disable the Use Global
Settings parameter. Then proceed to step 3.
3. In the "Autodial Number" field, specify the SIP number for this line that the IP phone dials
whenever the IP phone is off-hook as follows:
• If set to -1, then the global autodial settings for this IP phone to this line.
• If set to empty (blank), then disable Autodial on this line.
• If set to a valid SIP number, dial the SIP number specified for this line. For example: 8500
4. In the "Autodial Timeout" field, specify a value, in seconds, for the timer for this line as
follows:
• If you want the IP phone to autodial the number immediately (hotline) whenever the IP
phone is off-hook, accept the default value of 0.
• If you want to specify a length of time for the IP phone to wait before dialing the number,
enter the length of time (in seconds). For example: 30
Valid values are 0 to 120.
5. Click Save Settings to save your changes.
Global SIP Settings
4-98