Mitel 6867i Administrator's Manual page 566

Mitel 6800 Series SIP Phone Release 4.2.0 Administrator Guide
• options script
Notes:
1. If no Options URI script is configured, the local Options Menu on the phone displays
as normal.
2. If you configure password access to the Options Menu, this password is required
when accessing the local Option Menu, but is not required for the Options Key
redirection feature.
3. Pressing the Options Menu for redirection from the server does not interfere with
normal operations of the phone (for example, pressing the options menu when on
a call does not affect the call).
4. If the phone is locked, you must unlock the phone before accessing the Options
Menu redirect feature. After pressing the Options Key, the phone displays a screen
that allows you to unlock the phone before continuing.
An Administrator can configure the XML Options Key, redirection URI parameter using the
configuration files only.
Configuring XML Redirection of the Options Key
Use the following procedure to configure XML redirection of the Options key.
CONFIGURATION FILES
For the specific parameter you can set in the configuration files, see Appendix A, the section,
"Options Key Redirection Setting"
XML APPLICATIONS AND OFF-HOOK INTERACTION
A feature on the IP phone allows you to specify whether the phone is prevented from going
into the off-hook/dialing state when the handset is off-hook and the call ends.
By default, the phone behaves as follows:
You are in a call using the handset and the phone displays an XML application. The far-end
terminates the call, and a new XML application gets pushed/pulled onto the display. Since the
handset is off-hook and in idle mode, the "offhook idle timer" starts. When this timer expires,
the phone applies dial tone and moves to the off-hook/dialing state, which then destroys the
XML application that was being displayed.
With the "off-hook interaction" feature you can set an "auto offhook" parameter that determines
whether or not the phone is prevented from entering the off-hook/dialing state, if the handset
is off-hook and the call ends.
An Administrator can enable (allow phone to enter the off-hook dialing state) or disable (prevent
the phone from entering the off-hook dialing state) using the "auto offhook" parameter in the
configuration files only.
5-305
on .
page A-279