Discreet Ringing Settings - Mitel 6867i Administrator's Manual

For Expansion Module Softkeys
expmod1 key1 type: speeddialmwi
expmod1 key1 label: Peter
expmod1 key1 value:
+33123456,,,3456#0000#@domain;sip:voicemail_peter@domain
expmod1 key1 line: 3
For Hard Keys
hardkey1 type: speeddialmwi
hardkey1 value:
+33123456,,,3456#0000#@domain;sip:voicemail_peter@domain
hardkey1 line: 3
Refer to the following in Appendix A to configure a Speeddial/MWI key on the IP phone using
the configuration files.
CONFIGURATION FILES
To set a Speeddial/Conf key using the configuration files, see Appendix A,
Key/Keypad Key/Expansion Module Key/Hard Key Parameters"
DISCREET RINGING
The discreet ringing feature has been implemented beginning with Release 4.0.0 SP1. When
enabled, if a call is incoming, the phone will play the configured ring tone once only. All applicable
visual indicators (LED for the corresponding Line key, Message Waiting Indicator [MWI], etc...)
will behave normally.
Note: If a custom ring tone is selected and discreet ringing is enabled, the phone will
not play the custom ring tone during an incoming call. Ring tone 1 will be played once
instead.
Administrators can configure this feature by defining the "discreet ringing" parameter in the
configuration files (i.e. "0", the default, disables this feature, while "1", enables discreet ringing).
or by programming a key on the phone with the "Discreet Ringing" type feature using the Mitel
Web UI. After the key has been programmed, users can simply toggle the feature on or off by
pressing the programmed "Discreet" key.
Refer to the following in Appendix A to configure a Discreet Ringing key on the IP phone using
the configuration files.
CONFIGURATION FILES
To enable the feature and set a Discreet Ringing key using the configuration files, see Appendix
A,

"Discreet Ringing Settings"

Module Key/Hard Key Parameters"
on page A-271 and
"Softkey/Programmable Key/Keypad Key/Expansion
on .
page A-217
Operational Features
"Softkey/Programmable
on .
page A-217
5-186