Message Waiting Indicator Line - Mitel 6867i Administrator's Manual

CONFIGURATION FILES
For the specific parameter you can set in the configuration files, see Appendix A, the section,
"Status Code on Ignoring Incoming Calls"

MESSAGE WAITING INDICATOR LINE

A User or Administrator can configure the Message Waiting Indicator (MWI) to illuminate for a
specific line or for all lines. For example, if you configure the MWI LED on line 2 only, the LED
illuminates if a voicemail is pending on line 2. If you configure the MWI LED for all lines, the
LED illuminates if a voicemail is pending on any line on the phone (lines 1 through N).
A User can configure the MWI using the Mitel Web UI only. An Administrator can configure the
MWI on single or all lines using the configuration files or the Mitel Web UI.
CONFIGURING MESSAGE WAITING INDICATOR (MWI)
Use the following procedures to configure MWI on the IP phone.
CONFIGURATION FILES
For specific parameters you can set in the configuration files, see Appendix A, the section,
"Message Waiting Indicator Settings"
on .
page A-176
on .
page A-180
Operational Features
5-92