Mitel 6867i Administrator's Manual page 250

Mitel 6800 Series SIP Phone Release 4.2.0 Administrator Guide
As administrator, you configure Autodial globally, or on a per-line basis, for an IP phone. The
line setting overrides the global setting. For example, you can disable Autodial on a specific
line simply by setting the line's autodial number parameter to empty (blank).
WARNING:BEFORE CONFIGURING AUTODIAL ON YOUR IP PHONE:
• ANY SPEEDDIAL NUMBERS THAT YOU CONFIGURE ON AN IP PHONE ARE
NOT AFFECTED BY AUTODIAL SETTINGS.
• IF YOU CONFIGURE AUTODIAL ON YOUR IP PHONE, ANY LINES THAT
FUNCTION AS HOTLINES DO NOT ACCEPT CONFERENCE CALLS, TRANS-
FERRED CALLS, AND/OR INTERCOM CALLS.
CONFIGURING AUTODIAL USING THE CONFIGURATION FILES
You use the following parameters to configure Autodial using the configuration files:
Global Configuration:
• sip autodial number
• sip autodial timeout
Per-Line Configuration:
• sip lineN autodial number
• sip lineN autodial timeout
CONFIGURATION FILES
For specific parameters you can set in the configuration files, see Appendix A, the section,
"Autodial Settings"
CONFIGURING AUTODIAL USING THE MITEL WEB UI
Use the following procedure to configure Autodial using the Mitel Web UI.
By default, your IP phone uses the global settings you specify for Autodial for all lines on your
IP phone. However, you can also configure Autodial on a per-line basis.
MITEL WEB UI
Global Configuration:
1. Click on Advanced Settings->Global SIP->Autodial Settings.
4-97
on .
page A-123