Mitel 6800 Series SIP Phone Release 4.2.0 Administrator Guide
CONFIGURING THE SIP LOCAL DIAL PLAN, DIAL PLAN TERMINATOR, AND
DIGIT TIMEOUT
Use the following procedures to configure the SIP Local Dial Plan using the configuration files
or the Mitel Web UI.
CONFIGURATION FILES
For specific parameters you can set in the configuration files, see Appendix A, the section,
Local Dial Plan Settings"
MITEL WEB UI
1. Click on Basic Settings-> Preferences->General.
2. In the "Local Dial Plan" field, enter a valid local dial plan (up to 512 alphanumeric charac-
ters) for the IP phone. Default is X+#|XX+*. Enter prepended digits or a ";"to present a
secondary dial tone if required.
Note:
phone uses the default dial plan of "x+#|xx+*".
3. Enable the "Send Dial Plan Terminator" field by checking the check box. (Disable this
field by unchecking the box). Default is disabled.
4. In the "Digit Timeout (in seconds)" field, enter a timeout value. This is the length of time,
in seconds, he phone waits before dialing. Default is 4 seconds.
5-71
on
.
page A-67
If a User enters a dial plan longer than 512 characters, or a parsing error occurs, the
"SIP