Mitel 6867i Administrator's Manual page 668

Mitel 6800 Series SIP Phone Release 4.2.0 Administrator Guide
• Both Updates the configuration files and firmware automatically at the specified time
if the files on the server have changed.
Notes:
1. If a user is accessing the Mitel Web UI, they are not informed of an auto-reboot.
2. Any changes made using the Mitel Web UI or the IP phone UI are not overwritten
3. The resync time is based on the local time of the IP phone.
4. If the IP phone is in use (not idle) at the time of the resync check, the reboot
3. In the "Time (24-hour)" field, select the time that you want the update to take place.
Valid values are 00:00 to 23:30 (in 30 minute increments).
Notes:
1. The resync time is based on the local time of the IP phone.
2. The value of 00:00 is 12:00 A.M.
3. When selecting a value for this parameter in the Mitel Web UI, the values are
4. In the "Maximum Delay" field, specify the maximum time, in minutes, the phone waits past
the scheduled time before starting a checksync. The range is 0 to 1439. Default is 15.
5. In the "Days" field, specify the amount of days that the phone waits between checksync
operations.
The range is 0 to 364. Default is 0.
Note: A value of 0 causes the phone to checksync every time the clock reads the
proper time. A value of 1 forces the phone to wait 24 hours prior to doing the first
checksync.
6. Click Save Settings to save your settings.
Notes:
1. These changes are not dynamic.
2. You must restart your IP phone for the changes to take affect.
7. Click on Operation->Reset.
8. In the "Restart Phone" field click Restart to restart the IP phone and apply the update.
The update performs automatically at the time you designated.
8-9
by an auto-resync update. Auto-resync affects the configuration files only.
However, the settings in the Mitel Web UI take precedence over the IP phone
UI and the configuration files.
occurs when the phone becomes idle.
in 30-minute increments only.