Park/Pick Up Static And Programmable Configuration - Mitel 6867i Administrator's Manual

ENABLING/DISABLING SCA CALL BRIDGING FEATURE
Use the following procedure to enable/disable SCA call bridging on the IP Phones.
CONFIGURATION FILES
For specific parameters you can set in the configuration files, see Appendix A, the
section,
"Shared Call Appearance (SCA) Call Bridging"

PARK/PICK UP STATIC AND PROGRAMMABLE CONFIGURATION

The IP phones have a park and pickup call feature that allows you to park a call and pickup a
call when required. Administrators can configure call park and pickup using a static configuration
(6867i/6869i/6873i) or by using a programmable configuration (all 6800 series IP phones).
Notes:
1. The 6867i, 6869i, and 6873i IP phones accept both methods of configuration,
however to avoid redundancy, Mitel recommends you configure either a static
configuration or a programmable configuration.
2. For interoperability with the MiCloud Telepo for Service Providers call manager,
Administrators must use the programmable configuration method.
Administrators can use configuration files or the Mitel Web UI to configure a park/pickup static
or programmable configuration. Users can make changes to customize the label and the state
of the park/pick up keys using the Web UI.
The IP phones support the Park/Pickup feature on the Asterisk, BroadWorks, Sylantro, and
ININ PBX, and MiCloud Telepo servers.
The following paragraphs describe the static and programmable configuration of the call park
and pickup feature.
PARK/PICKUP STATIC CONFIGURATION
Notes:
1. This feature does not work when the "collapsed context user softkey screen"
parameter is enabled (see
page 153).
2. For interoperability with the MiCloud Telepo for Service Providers call manager,
Administrators must use the programmable configuration method.
The static method configures park and pickup on a global basis for all supported IP phones.
You can use the configuration files or the Mitel Web UI to configure a park/pickup static
configuration. In the configuration files, you use the following parameters to statically configure
park/pickup: "sprecode" and "pickupsprecode".
on
page A-90
"Shifting of Softkey Positions for Busy States"
Operational Features
.
on
5-214